Replacement Parts

Threaded Guide Rod fits manual sliding hammer for both the JMC Environmentalist's Sub-Soil Probe (0.8 inch diameter sampler) and the JMC Environmentalist's Sub-Soil Probe Plus (1.2 inch diameter sampler).

Threaded Collar fits manual sliding hammer for both the JMC Environmentalist's Sub-Soil Probe (0.8 inch diameter sampler) and the JMC Environmentalist's Sub-Soil Probe Plus (1.2 inch diameter sampler).

Small squeeze bottle of Aluminum Oxide Abrasive. Necessary to "rough up" the exterior of new sampling tubes so the foot operated jack will grip them.

The heavy (12 pounds) metal sleeve that moves up and down while pounding the sampling tube into the ground. Fits both the JMC Environmentalist's Sub-Soil Probe and the JMC Environmentalist's Sub-Soil Probe PLUS.

Pivot bolt and locknut for ESP or ESP+ pedal depressor.

Assembly fits manual sliding hammer for the JMC Environmentalist's Sub-Soil Probe PLUS (1.2 inch diameter sampler). This is the part that rests on the top of the sampling tube that fits up inside the heavy sleeve of the hammer.

Replacement footpedal for the JMC Environmentalist's Sub-Soil Probe PLUS. Footpedal usually needs replaced when foot-operated jack slips while extracting sampling tube from the ground.

Aluminum Washer fits manual sliding hammer for the JMC Environmentalist's Sub-Soil Probe PLUS(1.2 inch diameter sampler). Fits between the Threaded Collar(PN163) and the Aluminum Cylinder(PN453). This is the part that rests on the top of the sampling tube.

Component part of Guide Rod assembly for JMC Environmentalist's Sub-Soil Probe PLUS(1.2 inch diameter sampler).

• Precision machined aluminum
• Milled flats for tightening with a wrench